INSTALLATION METHOD 1.Insert the key into the hole located at the top of the dispenser push down with the key and pull the cover towards you the cover controls a power interlock switch located in the dispenser.In the colsed position the cover will actuale the power switch The dispenser will not activate when the cover is in the open position. 2.Using supplied installation dimension diagram as a template mark Screw hole locations on the wall all 3 holes and Installed supplied anchors in the wall Secure the dispensers with the supplied screws 3.Remove the battery compartment by depressing the compartment Lab pulling the compartment towards you.Insert six(6 JAA size alkaline as degraded in the battery compartment. Replace the battery compartment by Sliding the compartment towards the back of the dispersed until clicks into place USAGE 1.Fill the soap into the receplace or instailate one son bag with soap in the dispenser 2 Loading batteries and the LED win flash 3 Lines Indicating the dispenser is ready for use.place hand) underneath dispensary within 5 of the sensor the dispenser will dispense approximately 2 ml of soap(0.6ml foam soap) Into your hand Note 1. The dispenser cover must be closed to activale. 2. When the supply voltage is loo low, the LED will blink continuously, and then the dispenser won 1 work or leak, please change the batteries Immediately. 3 The minimum distance from dispenser bottom lo the bathroom table 25cm.